350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11250199 62-67 Nova Level 1 Air Suspension Pac
15. How do you set the pinion angle? On a single-piece shaft you want to set it up where a line drawn through the center of the engine c
16. Axle center is best determined by dropping a plum on the outside of the quarter panel and measuring into the axle. This must be done wit
Upper Bar Installation Jig This jig has been supplied to aid in the installation of the upper 4 link bar. It can be temporarily used to properly
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Should I weld my AirBar 4 link assembly in? Since we
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 24050701 7000 RQ Series ShockWaves 5” Stroke
7000 Series Shockwave Compressed Height 11.5” Ride Height 14.5” Extended Height
The care and feeding of your new ShockWaves 1. Although the ShockWave has an internal bumpstop, DO NOT DRIVE THE VEHICLE DEFLATED RESTING ON THIS
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 30154000 4000 Series RidePro 4 Way Compressor
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com ARC4000 Compressor System Instructions These are some
Mounting the RidePro Air Valves The valves, like the compressor, are sealed and can be mounted in the same locations. Although if the vehicle w
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11252409 62-67 Chevy II & Nova Front RQ Ser
ARC4000 Wiring at control panel: Gray connects to gauge light Red connects to “key on” power at fuse box
Relay Wiring Diagram
11252409 Installation Instructions 1. Raise and support vehicle at a safe, comfortable working height. Let the front suspension hang freely. 2
4. Apply thread sealant to the air fitting and screw it into the top of the Shockwave. 5. Place
The care and feeding of your new ShockWaves 1. Although the ShockWave has an internal bumpstop, DO NOT DRIVE THE VEHICLE DEFLATED RESTING ON THIS
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11257199 62-67 Nova Rear AirBar Components: 1
1. Raise the vehicle to a safe and comfortable working height. Use jack stands to support the vehicle with the suspension hanging freely. 2.
4. The upper bar mount will bolt to the bottom of the car using the factory shock bolts and locates off the factory shock mount. Note: The ba
8. Remove the crossmember and drop the 3/8” U-bolt through the holes. Reinstall crossmember and tighten with 3/8” nylocs and flat washers.
Kommentare zu diesen Handbüchern