350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11030199 55-57 Chevy Level 1 Air Suspension Pa
17. Bolt the lower Shockwave mount to the axle bracket using the 5/8” x 3/4” Allen bolt. Apply anti-seize to the threads. It is easier to r
25. Remove the spacer from between the axle and frame. 26. A new brake line tab is supplied and will mount just below the original.
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 24040701 7000 Series RQ Series Shockwaves RQ
7000 Series Shockwave Compressed Height 10.6” Ride Height 13” Extended Height
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 30154000 4000 Series RidePro 4 Way Compresso
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com ARC4000 Compressor System Instructions These are some
Mounting the RidePro Air Valves The valves, like the compressor, are sealed and can be mounted in the same locations. Although if the vehicle w
ARC4000 Wiring at control panel: Gray connects to gauge light Red connects to “key on” power at fuse box
Relay Wiring Diagram
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part #11012409 55-57 Chevy Car Front RQ Series ShockW
Installation Instructions 1. Raise and support vehicle at a safe, comfortable working height. Let the front suspension hang freely. 2. Remove th
8. Place the Shockwave up into the coil spring pocket with the stud protruding through the factory shock hole.
350 S. St. Charles St. Jasper, In. 47546 Ph. 812.482.2932 Fax 812.634.6632 www.ridetech.com Part # 11037199 55-57 Chevy Rear AirBar (One Piece Fra
1. Raise the vehicle to a safe and comfortable working height. Use jack stands to support the vehicle with the suspension hanging freely. 2. S
5. Use a couple clamps to secure the crossmember between the frame rails. Slide it forward to the edge of the body mounts. Drill the holes w
9. How do you set the pinion angle? On a single-piece shaft you want to set it up where a line drawn through the center of the engine c
10. Pinion angle must be set at ride height. At ride height there should be 4 1/2” between the axle and frame. 11. One trick to help main
Kommentare zu diesen Handbüchern